COMPAQ ARMADA M700 MINI-PCI V.90 MODEM/10/100 TX NIC COMBO DRIVER DOWNLOAD

Uploader: | Voodoohn |
Date Added: | 16 September 2009 |
File Size: | 61.66 Mb |
Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
Downloads: | 54330 |
Price: | Free* [*Free Regsitration Required] |
Standby can be initiated by you or by the system. Power cord set fittings appliance coupler and wall plug must bear the certification mark of the agency responsible for evaluation in the country where it will be used. Canada — Version 26 — August 8, To prevent damage to the computer and hard drive and loss of information, shut down the computer before removing the hard drive from the computer.
Reseat internal pointing device connector if applicable. Turn the base enclosure top side up with the front facing you.

Be sure to carefully note the size and location from which each screw was removed. Add to my manuals Add. The top cover is secured to the base enclosure by 15 screws that are two different sizes.
All other product names mentioned herein may be trademarks of their respective companies. Lift the LED cover straight up to remove it.
Full text of "Compaq Laptop Service Manual: Compaq Armada "
Removing the System Board Reverse the above procedure to install the system board. Test after each item: Hard drive, goto Section 2. In all cases, avoid bending, twisting, or tearing cables.
Check the setup utility for correct booting order. Do not remove the hard drive while the computer is on, midem/10/100 Suspend Standbyor in Hibernation. Although the Standby mode maintains the information and opens the file upon wake-up, any unsaved information is lost if the computer is turned off before ending Standby.
Maintenance and Service Guide Product Description The computer right side and rear panel components are shown in Figure and described in Table When a component such as the compaa, hard drive, system, or video is not in use, the component powers down to conserve power.
Operating system support for compaq portable products 22 pages. The information in this document is provided "as is" without warranty of any kind and is subject to change without notice, the warranties for Compaq products are set forth in the express limited warranty statements accompanying such products. The primary hard drive is being accessed.
The system will wake up from Standby when a key is pressed. Use care when handling the plastic parts. Refer to Figure for the computer mii-pci locations.
Compaq Armada M Quickspecs (Page 7 of 23)
Check for notebook properly seated in docking station, bent pins on cable, and for monitor connection. All passwords and all CMOS settings are clear. Make special note of the size and location of each screw during removal and replacement. Reload drivers and reconfigure. Often the spark is neither felt nor heard, but damage occurs. Connect AC power to the computer. Done Install bootable diskette and reboot amada.
Compaq Armada M700 Quickspecs Page 7
When servicing the computer, ensure that cables are placed in their proper location during the reassembly process. Compaq shall not be liable for technical or editorial errors or omissions contained herein.
Embedded numeric keypad Converts keys to numeric keypad.
Comments
Post a Comment